Whistler PRO-78GXi Manuel du propriétaire télécharger pdf (Page 10)

INSTALLATION

Power Cord Connection

• Plug the small end of the power cord into the unit’s

power jack.

• Plug the large end into the vehicle’s cigarette lighter socket.

NOTE: Cord fits tightly into detector. When installing the

cord, expect some resistance.

Installing the Hardwire Kit

The “U” type connector must be secured to a metal surface

that is electrically connected to the battery ground (negative)

terminal.

The spade type connector can connect to either live 12 volts

or switched 12 volts at your fuse panel accessory port. If no

port is available, cut off the spade terminal, expose 1/4 to

1/2 inch of wire, and splice into a source of 12 volt power.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 42 43

Pas de commentaire

Whistler PRO-78GXi Manuel du propriétaire Page 10